- Mhotspot troubleshooting update#
- Mhotspot troubleshooting android#
- Mhotspot troubleshooting software#
Simply unplug the power cable from your router/modem wait 30 seconds to a minute and then plug the power cord back into the router/modem.
Mhotspot troubleshooting android#
Performing a soft reset on your Wi-Fi network should be the first thing that you try when troubleshooting this issue, especially if this just suddenly happened for no logical reason and your phone was working fine and then just suddenly lost its internet connection.Ī soft reset of your network is a common solution and can often help fix the internet on your Android phone and luckily there is no loss of data whatsoever. Chances are good that the advice listed below will work and with any luck it should solve this internet issue with your Androids Wi-Fi connection quickly and with minimal fuss. If your cell phone can connect to and access the internet with other Wi-Fi networks without any issues then you might be able to hold off on troubleshooting your phone for Wi-Fi issues for the time being and concentrate on troubleshooting the Wi-Fi network that seems to be having problems as it is likely the reason for not having an internet connection.īut we’ll get to all that a little later. To find out for sure then you can try using your smartphone on another network. If other devices are able to connect to the Wi-Fi network and seem to be working properly this can (and often is) still the result of a network related problem. This is most often the result of a problem on or with the Wi-Fi network itself and NOT an issue with the phone. The most likely reasons why this is happening Different causes may require different methods of troubleshooting in order to get to the root of problem and prevent this from happening further. Make sure to follow all of the advice suggested in this guide. Since this issue can be caused by quite a few things this guide is going to include advice for troubleshooting both your Android smartphone and your Wi-Fi network and will begin with the more commonly successful solutions for resolving this problem and will proceed from there.
Some users have luck with just pulling the power and booting up the hotspot again, while others have to end up contacting Bobcat support and have them connect to the hotspot and fix things up.Does your Android smartphone connect to your Wi-Fi network but for some reason it cannot browse or use the internet? Here are some things that you can do to try and fix it.
Mhotspot troubleshooting update#
This can be caused by a bad firmware update and/or snapshot.
Mhotspot troubleshooting software#
The most common cause I’ve seen is that the miner software fails to start, causing the hotspot to reboot and try again. If you see it cycling between red, yellow and green, this typically means the hotspot is stuck rebooting. If you’re having issues with the hotspot it’s a good idea to keep an eye on the hotspot to make sure the LED stays green.
Ideally, the LED should be green which indicates the hotspot is booted and the miner software is running. The hotspot has a LED that indicates the current state of the hotspot. This might include network connectivity errors or other critical issues that need to be resolved.
If your hotspot mining software is having any issues chances are the error will be listed here. Scrolling all the way to the bottom you see an error section. Scrolling further down we see a helpful summary showing that our hotspot is connected to the Helium Peer-to-peer network and that port forwarding is in order, as evidenced by the nat_type value of ‘none’.